GE 20338 Bedienerhandbuch Seite 14

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 18
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 13
14
Operation instructions
1. Install a 9-volt battery (K) (not included
in the remote control).
Note: to prevent damage to transmitter
(J), remove the battery if not used for long
periods.
4. “OFF” button:
This button turns the fan off.
Speed settings for warm or cool weather
depend on factors such as the room size,
ceiling height , number of fans, and so on.
7. Warm weather - (Switch to the left -
Counterclockwise direction) A downward
air flow creates a cooling effect as shown.
This allows you to set your air conditioner
on a higher setting without affecting your
comfort.
2. Restore power to ceiling fan and test for
proper operation.
5. button: test for proper operation.
This button controls the light and also
controls the brightness setting. Press and
release the button to turn the light ON
or OFF. Press and hold the button to set
the desired brightness. The light key has
an auto-resume; it will stay at the same
brightness as the last time it was turned
off.
8. Cool weather - (Switch to the right -
Clockwise direction) An upward air flow
moves warm air off the ceiling are as
shown. This allows you to set your heating
unit on a lower setting without affecting
your comfort.
3. “HI, MED, and LOW” buttons: These
three buttons are used to set the fan
speed as follows:
HI = high speed
MED = medium speed
LOW = low speed
6. The reverse switch is located on the top
of motor housing. Slide reverse switch to
change fan rotation. Slide the switch to
the left for warm weather operation. Slide
the switch to the right for cool weather
operation.
Note: wait for fan to stop before reversing
the direction of the blade rotation.
9. Select a location to install your
Transmitter holder (L). Attach the
transmitter holder (L) with the two short
wood screws (N) provided.
9 V ol t
Ba ttery
L
N
IC ID: 2968A-7070T1
Operation is subject to the following two conditions:
1. The device may not cause interference
2. This device must accept any interference, including interference that may cause undesired operation of the device.
K
J
Forward Reverse
Seitenansicht 13
1 2 ... 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare