GE 20338 Bedienerhandbuch PDF herunterladen (Seite 13)

13

Fan installation

ATTACHING THE FAN BLADES

INSTALLING THE LIGHT KIT

1. Fasten blade (P) to fan motor assembly

(V) using the screws (F) and ﬂat washer (G)

supplied.

Repeat this procedure with remaining

blade assemblies.

1. Remove 1 of 3 mounting plate screws

(EE) from the mounting ring and loosen the

other 2 screws. (Do not remove)

Place the keyholes on the mounting

plate (W) over the 2 screws previously

loosened from the mounting ring. Turn the

mounting plate until it locks in place at the

narrow section of the key holes. Secure

by tightening the 2 screws previously

loosened and the one previously removed.

2. Remove 1 of 3 light kit mounting screws

(FF) from the mounting plate (W) and

loosen the other 2 screws. (Do not remove)

Lift the light kit (Y) up to the framed

mounting plate (W), make the 2-pin wire

connections:

-Red to red

-Black to black

Place the key holes on the LED light kit

(Y) over the 2 screws previously loosened

from the mounting plate (W), turn LED

light kit (Y) until it locks in place at the

narrow section of the key holes. Secure

by tightening the 2 screws previously

loosened and the one previously removed.

3. Raise the glass shade (Z) up against the

LED light kit (Y) and secure it to the fan by

twisting the glass shade (Z) clockwise until

snug. Do not overtighten.

NOTE: before starting installation,

disconnect the power by turning off

the circuit breaker or removing the

fuse at fuse box. Turning power off

using the fan switch is not sufﬁcient

to prevent electric shock.

V

P

G

F

W

EE

Y

FF

W

Z

Y

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare