GE LED Roadway Scalable Project Grade Cobrahead Installationsanleitung PDF herunterladen (Seite 3)

WIRING

• NOTE: Make all electrical connections in accordance

with the National Electrical Code and any applicable

local code requirements including grounding.

• NOTE: Verify that supply voltage is correct by

comparing it to nameplate.

PHOTOELECTRIC CONTROL

• When used, photoelectric (PE) receptacle should be

oriented so that the word “North” is directed toward

true north.

WARNING

Under no conditions should bolts be torqued to level greater

than

20 ft-lbs. (27.17 N-m)

CAUTION

Risk of injury. LED light source achieves full intensity

immediately upon being powered on. Do not look directly

at LED light source while energized.

• If more upward tilt of front of luminaire is needed, ﬁrst

loosen front two bolts slightly, lift luminaire and

re-snug the back two.

• If downward tilt is needed, reverse procedure by

loosening back two bolts ﬁrst.

• Once proper level has been achieved, tighten each

bolt to 17-19 foot-pounds (23.05-25.76 N-m),

alternating front to back along diagonal of bracket as

shown in Figure 1.

IEC Units:

• Terminals are readily accessible on terminal board

and will accept service leads ranging in size from

AWG No. 16 through No. 6.

• Service leads (See ﬁxture labeling for supply wire

temperature rating) should extend through mounting

bracket approximately 7 inches.

• Attach service leads to terminal board as shown on

luminaire nameplate.

• See table below for screw torques (See Table 1).

• Dimming Control Connections (See Table 2).

• A wiring diagram is provided on a label in luminaire.

FIGURE 1

TABLE 1. Terminal Board Torque Table UL Units

Wire Range Copper Aluminum Torque (in lbs)

10 - 16 SOL, STR 30

8 - 6 SOL, STR STR6 SOL, STR 45

TABLE 2. Dimming Control Connections

O VDC (-) Gray Lead

Up to 10 VDC (+) Violet Lead

IEC Units:

• Power supply cable and dimming control cable (if

necessary) must be provided by customer.

• Power supply cable (each conductor: phase, neutral

and ground) should be maximum of 12AWG (2.5mm

)

and minimum of 16 AWG (1.5mm

) solid or

stranded

with an overall cable diameter within the range of 7-12mm.

• Dimming control cable (0 to 10 VDC) (each conductor:

positive and negative) should be 18 AWG (1.0mm

)

solid or stranded with an overall cable diameter

within the range of 5-10mm.

Terminal Board Connections:

Terminal Board Position Supply Type

L1 High Line

G Ground

N/L2 Low Line/Neutral

1 2 3 4 5 6 7 8 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

GE LED Roadway Scalable Project Grade Cobrahead Installationsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein GE LED Roadway Scalable Project Grade Cobrahead