GE EANA Installationsanleitung PDF herunterladen (Seite 3)

3c Square Pole Architectural Arm Mounting

This luminaire has been conﬁgured the same as 3b

and an adapter plate has been included to mount to

a square pole. Hole pattern on square pole shall be in

accordance with Figure 5.

• Orient adapter block so that oval shaped through

hole is closer to top than bottom of adapter.

• With adapter block end oriented properly, mount

 adapterblocktopolewiththenutplateand3/8-16

 boltsandwashersuppliedasshown.Torque3/8-16

bolts to 25 - 32ft-lbs (34-43 N-m). (See Figure 6)

• Placextureagainstadapterblock.

• Install3/8bolt,lockwasherandwasherintopas

shown and tighten into adapter block.

(See Figure 7)

• OpenarmdoorandInstall3/8boltintotappedhole

of adapter block. (See Figure 7)

• Torque top and bottom bolts to 25 - 32 ft-lbs (34-43 N-m).

• Inspect installation to ensure ﬁxture is secure.

• NOTE: Make all electrical connections in accordance

with the National Electrical Code and any applicable

local code requirements.

• Strain relief for incoming power must be provided in

the pole top by the customer.

• Supply Wire Type and Size, for Customer Connection

to Terminal Board: 16 AWG (1.5mm

) to 6 AWG

(10mm

) Solid or Stranded.

WIRING

CAUTION

Risk of Damage or Injury: Door should be closed with

screw until ﬁxture in ﬁnal location.

DRILLING TEMPLATE

SQUARE POLE MOUNTING

FIGURE 5

.312 in. DIA.

(8 mm DIA.)

2.1960 in.

(56 mm)

.438 in. DIA.

(11 mm DIA.)

(2 PLACES)

5.2500 in.

(133 mm)

(MIN.)

1.250 in. DIA.

(32 mm DIA.)

(HOLE)

.656 in. (17 mm)

1.312 in. (33 mm)

4.3920 in.

(112 mm)

ADAPTER PLATE FOR

SQUARE POLE

FIGURE 6

Nut Plate

Adapter Block

3/8-16 Washer and Bolts

Torque Bolts to 25 - 32ft-lbs.

(34-43 N-m)

FIXTURE ARM TO ARM ADAPTER

Torque Top Bolt

to 25 - 32 ft-lbs.

(34-43 N-m)

Torque Bottom Bolt

to 25 - 32 ft-lbs.

(34-43 N-m)

FIGURE 7

1.8120 in.

(46 mm)

Terminal Board Connections:

Terminal Board Position Supply Type

L1 High Line

G Ground

 N/L2 LowLine/Neutral

• NOTE: Verify that supply voltage is correct by

comparing it to nameplate inside door or on carton.

1 2 3 4 5 6 7 8 ... 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

GE EANA Installationsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein GE EANA