GE E2SA Installationsanleitung PDF herunterladen (Seite 3)

• Open ﬁxture by unlocking two latches. Keep one

latch hooked onto the housing ear to suspend the

light engine.

UL Units:

• Terminals are readily accessible on terminal board

and will accept service leads ranging in size from

AWG No. 16 through No. 6.

• Service leads (See ﬁxture labeling for supply wire

temperature rating) should extend through mounting

bracket approximately 7 inches.

• Attach service leads to terminal board as shown on

luminaire nameplate.

• See table below for screw torques (See Table 1).

• A wiring diagram is provided on a label in luminaire.

NOTE: Make all electrical connections in accordance with

the National Electrical Code and any applicable local code

requirements including grounding.

NOTE: Verify that supply voltage is correct by comparing

it to nameplate.

WIRING

CAUTION

Risk of Burn: Allow light engine/ﬁxture to cool before handling.

TABLE 1.

Terminal Board Torque Table UL Units:

Wire Range Copper Aluminum Torque (in lbs)

10-16 30

8-6 SOL,STR STR6,SOL,STR 45

Terminal Board Connections:

(See Figure 3.)

Terminal Board Positions Supply Type

L1 High Line

G Ground

N/L2 Line/Neutral

• Rotate the light engine into position and secure by

snapping two latches on light engine to “ears” on

hood. (See Figure 4)

Figure 3

Figure 4

Tether

Ear

Latch

Wire

1 2 3 4 5 6 7 8 ... 11 12

Keine Kommentare

GE E2SA Installationsanleitung Seite 3