Ge ZICP360NXRH Bedienungsanleitung

Design Guide with InstallationInstructions36” Built-In Bottom Freezer Refrigeratorsmonogram.comPub. No. 49-60706-1Part No. 224D3735P001 03-14 GE

STEP 1 REMOVE PACKAGINGCAUTION: Refrigerator is much heavier at the WRSWKDQDWWKHERWWRP³EHFDUHIXOZKHQPRYLQJ:KHQusing a hand truck, handle f

11STEP 3 INSTALL SIDE PANELSSkip this step when not using side panelsIf you are using 1/4” side panels, they should be inserted into the case trim. F

Installation Instructions12• Insert the bolts into the toggle by hand until snug. Tighten with a wrench.Anti-Tip Wall BracketBoltWall ToggleDrywall or

13 STEP 5 LEVEL REFRIGERATORAll models have 4-point leveling. The front is supported by leveling legs, the rear is supported by adjustable wheels. Bo

STEP 7 ADJUST DOOR SWINGNOTE: This refrigerator has a 2-position door stop. When space does not allow the door to swing open fully to 130°, you may

15 STEP 9 INSTALL 1/4” FRAMED PANELS• There are two sets of holes in the handle side trim. Replace handle side trim by installing the original screw

16 STEP 9A INSTALL OVERLAY PANELS• There are two sets of holes in the handle side trim. Replace handle side trim by installing the original screws i

17 STEP 10 CONNECT WATER SUPPLY• Locate and bring tubing to the front of the cabinet.• Turn the water on to flush debris from line. Run about a quart

18Installation Instructions STEP 13 INSTALL TOEKICK• Locate the supplied toekick (shipped taped to the side of the refrigerator). Install the toekic

19Notes

Safety InformationSkill Level³ Installation of this refrigerator requires basic mechanical, carpentry and plumbing skills. Proper installation is the

NOTE: While performing installations described in this book, safety glasses or goggles should be worn.For Monogram® local service in your area, call

36" Frame to Frame Width*84" FromFloor toTop Frame35"Case Width*83-1/2" atRear25-3/8" Framed Models25-3/4" Stainless Ste

1/4"1/2"3/4"1"1-1/4"1"3/4" OverlayPanel(Nominal Size)Stainless Steel1/4"1/2"3/4"2"1-1/4"1-

1/4"1/2"3/4"1"1-1/4"1/4"1/2"3/4"1"1-1/4"1-1/2"23-7/8"From Rear of Refrigerator3/4" Ov

CUSTOMIZATION BASICS: Framed Or Overlay Panels, Custom Handles and Accessory KitsOverlay panelsYou may also choose to install custom overlay panels fr

1/4” FRAMED PANEL DIMENSIONS7If you choose to install framed panels, they must be cut to the dimensions shown. The panels will slide into the frame on

*84"2-9/16"24"*3" to 4"3/16"1-7/8"Design Guide8SIDE PANELSSide panels must be used whenever the sides of the refrig

Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-