Ge GEFanuc Automation Programmable Control Products T Bedienungsanleitung PDF herunterladen (Seite 145)

5-18 TCP/IP Ethernet Communications User’s Manual – January 1996

GFK-1004B

CHLTIME Command

The CHLTIME command has the form:

CHLTIME <minutes>

where <minutes> is a login timeout value expressed in minutes which has a range of 0

to 32767.

The CHLTIME command is used to change the login timeout value. This change remains

in effect until it is explicitly changed or until the next LOGOUT command is entered. If

the number of minutes specified is zero, no timeout is enforced.

A typical CHLTIME command is shown below:

= chltime 5

CHSOSW Command

When the Ethernet Interface is using a MMS-ETHERNET configuration mode, the

CHSOSW command has the form:

CHSOSW {<soft switch data>|def}

where <soft switch data> is the parameter string

[mac <MAC_address>]

[ldsrc <load_source>] [lanonline <yes_no>]

[bponline <yes_no>] [ldmac <load_addr>]

[mms <enable>]* [pgmr <enable>]

and where

<yes_no> = {yes | no}

<load_source> = {alt | net | loc}

<enable> = {dc | req | prhb}

and “CHSOSW def ” causes default values to be set.

* The MMS parameter is not used by the TCP/IP Ethernet Interface.

The CHSOSW command causes new data to be placed into the Soft Switches (EEPROM)

of the Ethernet Interface.

Notes

1. The changes made with either the Logicmaster 90 Configurator or

the CHSOSW command will not take effect until the next Ethernet

Interface restart.

2. If the PLC CPU has been properly configured through the

Logicmaster 90 Configurator (the normal case), the CHSOSW

Command will not be honored.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 267 268

Keine Kommentare

Ge GEFanuc Automation Programmable Control Products T Bedienungsanleitung Seite 145