Ge 45606 Bedienungsanleitung

GE SmartHome™Wireless Lighting ControlOn/Off/Dim Dimmer Switch45606Z-Wave® Certified Wireless Lighting Control

SHOCK HAZARD! Turn OFF the power to the branch circuit at the circuit breaker in your electrical service panel. Ensure power is OFF before you instal

Observe Important Wiring Information Always follow the recommended wire strip lengths and wiring combinations when making wiring connections.Important

Air Gap SwitchDuring normal operation, there is a small amount of power passing through the switch to the load even when the dimmer switch is turned o

Turn ON/OFF and control the brightness level of the connected incandescent lighting.- To turn the connected lighting ON: Tap the top of the rocker.- T

Please Note: After a power failure, the 45606 dimmer switch returns to OFF state.LED IndicatorThe LED will be lit when the connected lighting is OFF.

LED LightWhen shipped from the factory, the LED on the 45606 is set to turn ON when the connected light is turned OFF. This allows the LED to indicat

1. When Receiving a Z-Wave Dim Command- Parameter 7 (number of steps or levels)- Parameter 8 (timing of the steps)- Length: 1 Byte Valid Values:Parame

Restoring Factory DefaultsAll Configuration Parameters can all be restored to their factory default settings by using your master controller to reset t

FCC U2Z45606-7The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:The equipment has been test

Important Note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the ant

Introduction:Thank you for your purchase of a GE Z-Wave® control device. Z-Wave technology is designed to automate lighting/home control and provide

is a registered trademark of General Electric Company and is used under license to Jasco Products Company LLC, 10 E Memorial Rd., Oklahoma

This dimmer switch is designed for use only with permanently installed incandescent lighting fixtures. Do not use it to control fluorescent lighting, t

RISK OF FIRERISK OF ELECTRICAL SHOCKRISK OF BURNSWARNINGControlling Appliances:Exercise extreme caution when using Z-Wave devices to control appliance

Wireless RangeThis device complies with the Z-Wave standard of open-air, line of sight transmission distances of 65 feet. Actual performance in a hom

Effects of Home Construction on Wireless Range Between Z-Wave Enabled Devices.Note: The distances shown in the table below are typical examples. Actu

Please Note: Z-Wave home control networks are designed to work properly alongside 802.11 wireless computer networks, Bluetooth and other 2.4GHz or 5.

120 VAC60 HzBlack Black BlackGreenWhiteLightTypical Dimmer Wiring SchematicSingle, Dual and Triple Gang Boxes The metal plate surrounding the switch a

White (Neutral Not connected to 45606)Black (HOT or Load)GreenGreen or BareBlackBlack (Hot or Load)