GE WCVH6800 Bedienungsanleitung PDF herunterladen (Seite 22)

Before you call for service…

Problem Possible Cause What To Do

Incomplete cycle or timer Automatic load redistribution • Timer adds 3 minutes to cycle for each rebalance.

not advancing 11 or 15 rebalances may be done. This is normal operation.

Do nothing; the machine will finish the wash cycle.

Pump clogged • See page 13 on how to clean the Pump Filter.

Drain hose is kinked or • Straighten drain hose and make sure washer is not

improperly connected sitting on it.

Household drain may • Check household plumbing. You may need to call

be clogged a plumber.

Drain hose siphoning; drain hose • Ensure there is an air gap between hose and drain.

pushed too far down the drain

Loud or unusual noise; Cabinet moving • Washer is designed to move 1/4″ to reduce forces

vibration or shaking transmitted to the floor. This movement is normal.

All rubber leveling legs are not • Push and pull on the back right and then back left of your

firmly touching the floor washer to check if it is level. If the washer is uneven, adjust

the rubber leveling legs so they are all firmly touching the

floor and locked in place. Your installer should correct this

problem.

Unbalanced load • Open door and manually redistribute load. To check

machine, run rinse and spin with no load. If normal,

unbalance was caused by load.

Pump clogged • See page 13 on how to clean the Pump Filter.

No power/washer not Washer is unplugged • Make sure cord is plugged securely into a working outlet.

working or dead

Water supply is turned off • Turn both hot and cold faucets fully on.

Circuit breaker/fuse is • Check house circuit breakers/fuses. Replace fuses or

tripped/blown reset breaker. Washer should have separate outlet.

Automatic self system checks • First time the washer is plugged in, automatic checks

occur. It may take up to 20 seconds before you can use

your washer. This is normal operation.

Snags, holes, tears, rips Overloaded • Do not exceed maximum recommended load sizes.

or excessive wear See recommended maximum load sizes on page 11.

Pens, pencils, nails, screws or • Remove loose items from pockets.

other objects left in pockets

Pins, snaps, hooks, sharp • Fasten snaps, hooks, buttons and zippers.

buttons, belt buckles, zippers

and sharp objects left in pockets

Control time wrong This is normal • During spin the washer may need to rebalance the load

or changes sometimes to reduce vibrations. When this happens,

the estimated time is increased causing time left to

increase or jump.

Not enough water This is normal • Horizontal washers do not require the tub to fill with water

like top-load washers.

Washer pauses or has Pump clogged • See page 13 on how to clean the Pump Filter.

to be restarted, or washer

door is locked and will

not open

Door unlocks or This is normal • Front-load washers start up differently than top-load

press START and machine washers, and it takes 30 seconds to check the system.

doesn't operate The door will lock and unlock.

Incorrect operation • Simply open and close the door firmly; then press START.

Consumer Support

Troubleshooting Tips

Operating Instructions

Safety Instructions

Installation

Instructions

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

GE WCVH6800 Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Waschmaschinen GE WCVH6800