Ge 500A187P044 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Waschmaschinen Ge 500A187P044 herunter. GE 500A187P044 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Installation
Electric Dryer
Instructions
44
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT " Save these
instructions for local inspector’s use.
IMPORTANT “ Observe all
governing codes and ordinances.
Note to Installer - Be sure to leave these instructions with
the customer.
Note to Customer - Keep these instructions with your Use
and Care Book for future reference.
This dryer must be exhausted outdoors.
• Before the old dryer is removed from service or discarded,
remove the dryer door.
• Service information and the wiring diagram are located in
the control console.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance is
used near children.
FOR YOUR SAFETY:
A
WARNING
Use only rigid metal or flexible metal 4-in. diameter
ductwork for exhausting to the outdoors. Never
use plastic or other combustible, easy-to-puncture ductwork.
This appliance must be properly grounded and installed
as described in these instructions.
Do not install or store appliance in an area where it
will be exposed to water and/or weather
Install the dryer where the temperature is above 50^F
for satisfactory operation of the dryer control system.
NOTE: Installation and service of this dryer
requires basic mechanical and electrical skills.
It is your responsibility to contact a qualified
installer to make the electrical connections.
TOOLS YOU
WILL NEED
FLAT BLADE SI 'ER
PHILLIPS SCREWDRIVER
LEVEL
4" DIA. METAL DUCT
(RECOMMENDED)
MATERIALS YOU WILL NEED
4“ DUCT
CLAMPS (2)
OR
4“ SPRING
CLAMPS 12)
4-DIA. METAL
ELBOW
EXHAUST HOOD SAFETY GLASSES
4" DIA. FLEXIBLE METAL DUCT
(IF NEEDED)
DUCT TAPE
GLOVES
3/4- STRAIN RELIEF
UL RECOGNIZED
DRYER POWER
CORD KIT
(NOT PROVIDED
WITH DRYER)
UL RATED 120/240V, 30A
WITH 3 OR 4 PRONGS.
IDENTIFY THE PLUG TYPE
AS PER THE HOUSE
RECEPTACLE BEFORE
PURCHASING LINE CORD.
Step 1 Prepare the Area and Exhaust for Installation of
New Dryer (see section 1).
Step 2 Check and Ensure the Existing External Exhaust is
Clean (see section 1) and Meets Attached Installation
Specifications (see section 3).
Step 3 Remove the Foam Shipping Pads (see section 1).
Step 4 Move the Dryer to the Desired Location.
Step 5 Connect the Power Supply (see section 2).
Step 6 Connect the External Exhaust (see section 4).
Step 7 Level Your Dryer (see section 5).
Step 8 Check the Operation of the Power Supply
and Venting.
Step 9 Place the Owners Manual and the Installation
Instructions in a Location Where They Will Be
Noticed By the Owner.
For Alcove or Closet Installation, see section 6.
For Bathroom or Bedroom Installation, see section 7.
For Mobile or Manufactured Home see, section 8.
For side or bottom exhaust, see section 9.
Seitenansicht 0
1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - Instructions

InstallationElectric DryerInstructions44BEFORE YOU BEGINRead these instructions completely and carefully.IMPORTANT " Save theseinstructions for l

Seite 2 - Installation Instructions

Installation InstructionsMinimum Clearance Other Than Alcove or Closet InstallationMinimum clearance to combustible surfaces and for air opening are:

Seite 3 - EXHAUST SYSTEM CHECK LIST

Installation Instructions1. Turn off the circuit breaker (s) (30 amp) or remove the dryer’s circuit fuse at the electrical box.2. Be sure the dryer co

Seite 4

Installation Instructionsa EXHAUST CONNECTIONWARNING - TO REDUCE THE RISK OF FIRE OR PERSONAL INJURY;• This dryer must be exhausted outdoors.• Use onl

Seite 5

Installation Instructions, Indoor ExhaustingUSING FLEXIBLE METAL DUCTSIf rigid all-metal duct cannot be used, then flexible all-metal ducting can be u

Seite 6

Installation InstructionsS DRYER EXHAUST TO RIGHT, LEFTOR BOTTOM CABINETA WARNING - BEFORE PERFORMING THIS EXHAUST INSTALLATION, BE SURE TO DISCONNECT

Seite 7 - Pub #31-16073

Installation InstructionsADDING ELBOW FOR EXHAUST THROUGH BOTTOM OF CABINET• Insert the elbow through the rear opening and connect it to the dryer int

Seite 8

Notes

Verwandte Modelle: DMCD330EHWC

Kommentare zu diesen Handbüchern

Keine Kommentare