GE RAB71B Installationshandbuch PDF herunterladen

Installation instructions

for your new

RAB-71 Standard

or Extended Room

Air Conditioner Case

Before you begin—Read these instructions completely and carefully.

IMPORTANT—OBSERVE ALL GOVERNING CODES AND ORDINANCES.

Note to Installer—Be sure to leave these instructions with the Consumer.

Note to Consumer—Keep these instructions with your Use and Care Book for future reference.

Critical Dimensions

Note:

Care should be taken in location of electrical supply

entry in relationship to wall sleeve to assure access

to power once the unit is installed.

Ceiling

“A”

“B”

“C”

Roomside

Outside wall

“D”

Finished floor or top of carpet

Recommended

Dimensions Installation Clearance

A Top of case to finished

ceiling – 3″ min.

B Projection of case into

room – 0″ min. (no sub-base)

⁄8″ min. when

sub-base is used.

If more than 6″ of the case

projects into the room, a

sub-base or other support

is recommended.

C Projection of case to

outside – 1/4″ min.

D Height above finished floor or top

of carpet – 0″ min. without sub-base

3″ min. with sub-base

E Left/Right side of case to

adjacent wall – 2″ min.

Top of case

Outside wall

“E”

Pub. No. 30-7795-2

04-00 JR

INSTALL CASE LEVEL IN ALL DIRECTIONS

Note:

• Handle the case carefully.

• The cardboard stiffener inside the case, and the rear

protective panel must remain in place until the chassis

is installed to assure case rigidity and squareness.

• If a sub-base is to be used, it may be desirable to

assemble it to the case before securing the case in

the wall.

Case location

As a general rule the air conditioner should be

located in an outside wall to assure proper

distribution of conditioned air. It should be located

in a portion of the wall where there is no electrical

wiring or plumbing, and where there are no

obstructions immediately inside or outside.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Air Conditioner Case

Installation instructionsfor your newRAB-71 Standard or Extended RoomAir Conditioner CaseBefore you begin—Read these instructions completely and caref

Seite 2 - Preparation of the case

STEP 1Preparation of the wallThe wall case should be installed during constructionand lintels should be used to support the block abovethe wall case.

Seite 3

3STEP 3Installation of the case in the wall opening1. Position the case into the wall. Refer to chart onpage 1 for roomside projection. The rear (outs

Seite 4 - DRAIN KIT

4DRAIN KITIf it is necessary to install a drain kit on this wallcase, the following kit is available:RAD10 Internal/External Drain1. With an “Internal