Installation Instructions
Adaptors for DR2
LED Traffic Signal Lamps
Installation Steps:
NOTE: To avoid scratches to the optical surface, DO NOT place lamp on the front surface.
Step 1: Install o-ring in the groove between
external lens and black housing.
Step 2: Pass wires through adaptor ring.
Step 3: Align the arrow on the adapter as shown
in the image.
…Page 2
Ensure O-ring
is installed
Risk of Damage
Failure to place o-ring will not
seal the adaptor/lamp interface.
Prepare Electrical Wiring
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Electrical Requirements
x Do not use in wet locations
x Follow all National Electric Codes
(NEC) and local codes.
Kommentare zu diesen Handbüchern