GE JV247PWW Bedienungshandbuch PDF herunterladen (Seite 6)

BEFORE YOU BEGIN

Installation Range Hood

Instructions

Read these instructions completely and carefully.

•

IMPORTANT – Save these instructions for

local inspector’s use.

•

IMPORTANT – Observe all governing

codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these instructions

for future reference.

• Skill level – Installation of this appliance requires

basic mechanical and electrical skills.

• Completion time – 30 minutes–3 hours

• Proper installation is the responsibility of the installer.

• Product failure due to improper installation is not

covered under the Warranty.

NOTE: Read the ductwork sections only if you do not

have existing ductwork. If you have existing ductwork,

skip to the “Damage” section and proceed.

WARNING – TO REDUCE THE RISK OF FIRE AND

723523(5/<(;+$867$,5%(685(72'8&7$,52876,'(³

DO NOT VENT EXHAUST AIR INTO SPACES WITHIN WALLS OR

CEILINGS OR INTO ATTICS, CRAWL SPACES OR GARAGES.

7KHYHQWLQJV\VWHPPXVWH[KDXVWWRWKHRXWVLGH

This hood can be vented vertically through upper cabinets or

horizontally through an outside wall. Ductwork is not included.

Exhaust connection:

7KHKRRGH[KDXVWKDVEHHQGHVLJQHGWRPDWHZLWK

standard 3

ø4s[s rectangular ducting or 7s diameter

round ducting.

If a 6s round duct is required, a rectangular-to-round

transition adaptor must be used*. Do not use less than a

6s diameter duct.

Maximum duct length:

For satisfactory air movement, the total duct length

of a 3

ø4s[s rectangular, 6s or 7s diameter round

duct should not exceed 65 equivalent feet. See

the WORKSHEET–CALCULATE TOTAL EQUIVALENT

DUCTWORK LENGTH section.

NOTE: It is important that ducting be installed using the

most direct route and with as few elbows as possible.

7KLVHQVXUHVFOHDUYHQWLQJRIH[KDXVWDQGKHOSVSUHYHQW

blockages. Also, make sure dampers swing freely and

nothing is blocking the ducts. When applicable, install any

makeup (replacement) air system in accordance with local

building code requirements. Visit GEAppliances.com for

available makeup air solutions.

Elbows, transitions, wall and roofcaps, etc.,

present additional resistance to airflow and are equivalent

to a section of straight duct longer than their actual

physical size. When calculating the total duct length, add

the equivalent lengths of all transitions and adaptors plus

the length of all straight duct sections. The charts on the

following pages show you how to calculate total equivalent

GXFWZRUNOHQJWKXVLQJWKHDSSUR[LPDWHIHHWRIHTXLYDOHQW

length of some typical ducts.

DUCTWORK REQUIREMENTS

WARNING – Before beginning the

installation, switch power off at service panel and

lock the service disconnecting means to prevent power

from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten

a prominent warning device, such as a tag, to the

service panel.

FOR YOUR SAFETY:

Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com

An optional Power Cord Connection Kit, model JXHC1,

LVDYDLODEOHDWH[WUDFRVWIURP\RXU*(VXSSOLHUIRU

installation using a standard 3-prong, grounded wall

outlet. Follow the Installation Instructions packed with

the kit to connect the power cord to the range hood.

OPTIONAL POWER CORD KIT JXHC1

* IMPORTANT: If a rectangular-to-round

transition adaptor is used, the bottom

corners of the damper will have to be

cut to fit, using the tin snips, in order

to allow free movement of the damper.

Equivalent lengths of duct pieces

are based on actual tests and reflect

requirements for good venting

performance with any hood.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

GE JV247PWW Bedienungshandbuch Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Dunstabzugshauben GE JV247PWW