GE RS Series Installationsanleitung PDF herunterladen

For GU24 pin

base sockets

For standard

medium base

sockets

Lighting

(RS Series)

Lumination

LED Luminaire

Installation Guide

BEFORE YOU BEGIN

Read these instructions completely and carefully.

imagination at work

Save These Instructions

Use only in the manner intended by the manufacturer.

If you have any questions, contact the manufacturer.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class [B] RFLD

complies with the Canadian standard ICES-003. Ce DEFR de la classe [B] est conforme á la NMB-003 du Canada.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

Components Supplied

• One LED retrot

• One installation instructions sheet

WARNING/AVERTISSEMENT

• Risk of re or electric shock. LED Retrot Kit installation requires

knowledge of luminaires electrical systems. If not qualied, do

not attempt installation. Contact a qualied electrician.

• Risk of re or electric shock. Install this kit only in the luminaires

that have the construction features and dimensions shown in

the photographs and/or drawings.

• Do not make or alter any open holes in an enclosure of wiring or

electrical components during kit installation.

• To prevent wiring damage or abrasion, do not expose wiring to

edges of sheet metal or other sharp objects.

• This device is not intended for use with emergency exits.

• Min. lamp compartment dimensions 15 (dia) x 17 (h) mm.

• Risque de choc électrique, le kit d’installation LED Retrot requiert une connaissance

des systèmes électriques des luminaires. Si vous n’êtes pas qualié, ne tentez pas

l’installation. Contactez un électricien.

• Risque d’incendie ou de choc électrique. N’installez ce kit que dans les luminaires qui

ont les caractéristiques de conception et les dimensions indiquées sur les photos et/ou

schémas.

• Ne faites/n’altérez pas les trous ouverts dans l’enceinte de câblage ou composants

électriques lors de l’installation du kit.

• Pour prévenir tout risque de dommage ou abrasion, n’exposez pas le câblage à des

lames métalliques ou autres objets coupants ou pointus.

• Cet appareil n’est pas conçu pour utilisation avec sortie de secours.

• Dimensions minimum du compartiment des lampes : 15mm (diamètre) x 17 (h) mm.

The units covered in this report are intended to retrot Type IC or non-IC recessed mount Listed luminaires with instructions to remove the existing

trim. The minimum dimensions of luminaries are tabulated below. These products are intended to be used in dry or damp locations. These products are

classied as to FIRE and SHOCK hazards only.

1 2

Inhaltsverzeichnis

Seite 1 - LED Luminaire

For GU24 pin base socketsFor standard medium base socketsGELighting(RS Series)LuminationTM LED LuminaireInstallation GuideBEFORE YOU BEGINRead these i

Seite 2 - Prepare Electrical Wiring

IND102-0522141 347Remove lamp from the packaging and check that the mounting clips are rmly attached.Remove existing trim and bulb, revealing the exi